Traceback error

[Larz60+]

Looking back at the error message you had, I now see that you have a virtual environment set up.
This is good, but also the reason that you are seeing errors, and an easy fix.
Virtual environments isolate your project so that is has it's own environment.
You have to install packages within that environment taht will be used by the project.
This keeps the package as small as possible, and also keeps it immune to problems when the system changes.
So, Here's what needs to be done.
with your project loaded in PyCharm:

• Click file --> settings
  
• In the left pane of the settings window, click on down arrow to left of your project
  
• In the sub menu that pops up, click Project Interpreter
  
• You will see a list of all packages installed in the virtual environment, as well as the selected Python Interpreter.
  
• Make sure the proper interpreter is selected, if not select the proper one. If it's not shown (and only if not shown: click on the gear on right, then show all.. Be careful here, and make sure you don't pick an interpreter that is attached to another project, It should be youre base interpreter on your C drive. If its tere, select it and return to settings window by clicking OK. If it's not there, click cancel, gear again, and add local. A new window pops up, select virtual environment new environment, make sure location shows project location, if not make it so. Now set base interpreter to python 3.6 on C drive click ok to get back to settings page.
  
• Internet access is required for the following:
  
• You will see a list on packages installed to the virtual environment. if you don't see any of the following, they will need to be installed here:
  
• BeautifulSoup4
  
• lxml
  
• requests
  
• wxpython
  
• If any of these is missing, install as follows: click green + symbol on right
  
• For each missing package, type the package name, for example requests. The requests package should be highlighted in the package list, if not, check spelling.
  
• once name is highlighted, click Install package
  
• when complete, a message highlighted in green saying Package 'requests' installed successfully.
  
• repeat for each package, when done X out of window.
  
• You should now see all packages in the settings window list, if not go back and get missing package(s)
  
• Clock OK on settings window.
  
• Try running program again
  

I will be on and off Friday, but please let me know how you make out. I will respond when I read posts.